This parquet represents a square board (or a carpet), typed of laths of different length and a thickness, pasted on a dense paper a face sheet. The back party a board paste on the basis by means of bitumen mastic. Besides, there is a parquet pasted by the return (back) party on any strong elastic material which then remains in a design and after nastilki a parquet. Carpets happen the different size, therefore they are necessary for selecting according to the sizes of a premise, proceeding from that that indoors at possibility the integer of squares-carpets kept within.
Preliminary for each premise it is necessary to pick up carpets in the sizes, drawing, colour and breeds of wood. The good selection considers such when the Integer of carpets keeps within without any additives this or that premise. The selected carpets are recommended to be sorted once again so that one shade carpets went to the first row, another - in the second etc.
Lay such parquet on the rigid basis, basically on a concrete coupler. The coupler should be executed very precisely, with deviations no more than 1 mm. Check is carried out fugovannoj rejkoj in the length 2 m.
Nastilka of such parquet is made on mastics. The back party of a carpet should adjoin to mastic and a coupler not less than on 80% of the area of a carpet. At 100%-s' adjunction of a carpet to a coupler the most reliable gluing is provided.
Durability also depends On density of mastic priklejki. Preliminary before gluing of a parquet mastic it is necessary to mix and check up carefully its density (the item "¦рё=шъш" see; fig. 32).
lay the Type-setting parquet so (fig. 36). Along two walls pull two cords, perpendicularly to each other. Instead of cords about walls it is possible to strengthen, having put on an edge at an angle 90 ° to each other, two fugovannye rejki in the thickness of 15-20 mm. Rejki paste to the basis hot mastic or it is strong krepjat to walls. Rejki - a reliable emphasis for carpets of a type-setting parquet. After removal reek the necessary backlash between a wall and a carpet of a parquet which is closed further by a plinth is formed. Rejki it is necessary to take such length that along them it was possible to lay 6-8 carpets.
The First carpets put along directing reek. At first lay the first rows on two parties, then - the second. The first carpet of the second row put in a corner between the two first carpets, and the second carpet - between the first and the second.
Each following carpet rests edges not against one, and in two before laid that provides equal packing.
To Lay a type-setting parquet conveniently together: one makes and brings materials, pours cold mastic and levels its gear shpatelem, the second stacks the first carpet in a corner, is dense utaplivaja it in a mastic layer. Other carpets consistently stack, densely pressing them to the basis and earlier laid carpets, pripressovyvaja slightly a hammer.
Mastic level gear shpatelem, allowing to receive on the basis a thin equal layer of mastic of an identical thickness. The mastic squeezed out from seams there and then remove shpatelem, a knife or other sharp tool and wipe absolutely dry rag. That the layer or mastic traces were not appreciable, such places is better protsiklevat.
That mastic was not squeezed out at packing of carpets, them at first press edges to earlier laid carpets, and then lower on mastic.
Through 3-5 sut after the termination nastilki carpets, i.e. After full hardening of mastic, from a parquet, nastlannogo on a floor, remove a paper. A paper preliminary slightly humidify with a rag or a brush moistened in water. Definitively finish a parquet after installation of plinths.